My wires are too damn short.

   / My wires are too damn short. #21  
I am replacing an old floodlight setup on the side of my house with a bigger LED light. The problem is after removing the old fixture, I realized the wires coming from the house are not long enough to reach into the new fixture. I was thinking of putting a junction box where the old light was and running wires from there to the new light.

Any better ideas out there?

Thanks
Dave

View attachment 812123
Your idea is the best to code idea, splices are supossed to be inside a junction box.
 
   / My wires are too damn short.
  • Thread Starter
#22  
I went to Lowes and purchased a junction box and cover.

89ff7320-b650-489f-bc7f-eb299e5f61e2.jpg



I picked up some In-Sure® Push-In Wire Connectors.

38655671-6ba9-4b16-a2f5-ba89fd88cf1d.jpg


I used a 12" length of MC wire cable. (Three wire with covered ground) and some clamps to finish the job. Is it totally waterproof, No. It's on the north side of the house under a 2' overhang. I have never seen that area get wet.

I also turned off the power. 😁

 
   / My wires are too damn short. #23  
I went to Lowes and purchased a junction box and cover.

View attachment 812370


I picked up some In-Sure® Push-In Wire Connectors.

View attachment 812371

I used a 12" length of MC wire cable. (Three wire with covered ground) and some clamps to finish the job. Is it totally waterproof, No. It's on the north side of the house under a 2' overhang. I have never seen that area get wet.

I also turned off the power. 😁

Personally, I see that as a good install with the 2 foot roof overhang.

I always got a kick out of inspectors who would write a correction notice on an installation like this. Inspecting to the letter of the code, instead of the intent of the code. It takes just a little discernment to see you got it right, some individuals lack this ability.
 
   / My wires are too damn short.
  • Thread Starter
#24  
Personally, I see that as a good install with the 2 foot roof overhang.

I always got a kick out of inspectors who would write a correction notice on an installation like this. Inspecting to the letter of the code, instead of the intent of the code. It takes just a little discernment to see you got it right, some individuals lack this ability.
20230722_143048.jpg
 
   / My wires are too damn short. #25  
Nice! Just FYI, you might want to paint the armored cable. It isn't super water resistant, and condensation can cause it to rust after a bit, at least around here.

All the best,

Peter
 
Last edited:

Tractor & Equipment Auctions

2023 Bobcat T770 Skidloader (RIDE AND DRIVE) (LIKE NEW) (A50774)
2023 Bobcat T770...
New Lewis Brothers MFG DB2 Poultry Housekeeper (A51039)
New Lewis Brothers...
2017 PETERBILT 579 TANDEM AXLE SLEEPER (A51222)
2017 PETERBILT 579...
2015 FREIGHTLINER CASCADIA DAY CAB (A51222)
2015 FREIGHTLINER...
2018 John Deere 245G LC Excavator - Hydraulic Thumb, Tooth Bucket, 56K LB Class (A51039)
2018 John Deere...
2025 JMR 36in Mini Skid Steer Bucket Attachment (A50322)
2025 JMR 36in Mini...
 
Top