MX Cab Aux light harness?

[cdnt]

A few questions. I’m trying to install a strobe on top of my cab and replace the work lights with LEDs front and rear.

In the wiring harness that powers the rear work light and turn signal, there seems to be and extra “micro” plug. Does anyone know what it’s for? See picture below.

I’m not sure that’s it’s powered or switched. I tried using a DMM but very hard to get to the pins and didn’t seem to get any power with all the lights / switches on.

Finally does anyone know what type of connectors these are? I can cut them off but would be ideal to use the plug if I can.

 

[Michael In Tennessee]

Interesting. Get out your multitester and figure it out.

On my MX4800, I have a pair of bullet connectors there for aux lights. You have a more interesting connector, but I don't know what it is.