Mpower 85 beeper

[Corncobrob]

My Mahindra mpower 85 beeper starts after running the tractor about 20 minutes and won’t quit till the engine completely shuts off when you kill it. There are no lights on the dash and the healthy light will still cycle on despite the beeping. I have replaced the transmission scavenger pump sending unit before but that beeping started right at 5 minutes of run time. Any ideas?

 

[priberc]

My Mahindra mpower 85 beeper starts after running the tractor about 20 minutes and won’t quit till the engine completely shuts off when you kill it. There are no lights on the dash and the healthy light will still cycle on despite the beeping. I have replaced the transmission scavenger pump sending unit before but that beeping started right at 5 minutes of run time. Any ideas?

Had the same problem on mine. There is a switch or sensor for the scavenger pump on top of the transmission. That’s your trouble I think.
I have an open station and with out disassembling the platform I was able to change it with a little patience/ingenuity.
If you look across the top of the trans you should see the wire that leads to it. If memory serves it is about centre of the trans.
Scavenger pump oils the trans. Your transmission is full? Might be worth checking……

 

[priberc]

My Mahindra mpower 85 beeper starts after running the tractor about 20 minutes and won’t quit till the engine completely shuts off when you kill it. There are no lights on the dash and the healthy light will still cycle on despite the beeping. I have replaced the transmission scavenger pump sending unit before but that beeping started right at 5 minutes of run time. Any ideas?

How did you make out?

 

[ACWSPEEDPATROL]

What is turning out to be a common problem might mean your new sending unit was bad to begin with.

 

[kneedeep]

Disconnect the beeper. Part of the system to meet standards to get sold in USA.
Same as the little engine lite that comes on ever so often that indicates to see dealer, nothing to see.

 

[ACWSPEEDPATROL]

My Mahindra mpower 85 beeper starts after running the tractor about 20 minutes and won’t quit till the engine completely shuts off when you kill it. There are no lights on the dash and the healthy light will still cycle on despite the beeping. I have replaced the transmission scavenger pump sending unit before but that beeping started right at 5 minutes of run time. Any ideas?

Sure would like to know how you made out with this situation!