Middle buster build

[ih784]

Hey folks. Ive got the material to build a middle buster. I do not however have the plow or mold board itself. I was hoping to get some pictures or dimensions for the blade mount point ie: inside width of where the blade attaches to the the ripper or flat bar in my case and how the blade is bolted. Are there two pieces of smaller flat bar on the side of the larger main flat or is the solid shank ripper drilled straight through. What angle is the blade mounted to the shank? Most look to be 30 degree or so.

 

[bullbreaker]

See if this helps or something off this site.

Worksaver