bbradley57
New member
I just changed the fluid and filter now the engine is under a strain...when I cycle bucket it smooths out...stop cycling bucket and it goes back to straining.... ???
MF GC1720 Hydraulic issue
- Thread starter bbradley57
- Start date
- Views: 5432
OP
bbradley57
New member
Got it....hooked up hydraulic lines to 3 point hitch...cycled it a few times...Bingo 
Hooked backhoe up and all is well in Massey land !
Hooked backhoe up and all is well in Massey land !
AlbanySamurai
Bronze Member
Got it....hooked up hydraulic lines to 3 point hitch...cycled it a few times...Bingo
Hooked backhoe up and all is well in Massey land !
Good to know, I will be doing the same soon.
OP
bbradley57
New member
Had me worried ! I guess the system has to make that loop !
Yes, or you are deadheading the pump.
Which means the fluid has no where to go.
In the future, you should post these kinds of questions in the Massey Ferguson owning and operating forum. That's where all the GC owners are.
If they see your question faster, you may get help faster.
WranglerX
Super Member
Yes, BH is in between PB port of FEL and 3PH.... With out BH connected or hoses being "looped" flow is restricted (non existent) ....
Dale
AlbanySamurai
Bronze Member
Dale,
When you loop the flow with BH off, does it matter which female you use with the male? There is two female and one male. I think one and red and the other blue zip ties.
WranglerX
Super Member
Yes.... One female is for 3PH and one female goes to "tank".... Connect one combination up if 3PH does not work, switch combination....
Image is backhoe side, but it should be instructive....Once you have correct combination mark them for future...
Dale
AlbanySamurai
Bronze Member
Thank you! Very helpful!
MF RED in MT
Veteran Member
Welcome to TBN,
If you have a Backhoe Operators Manual, refer to the section "Detaching Backhoe from Tractor", that should explain this very well a long with pictures.
On my GC2410, the "Sump" hose (tank hose) that is left with only the dust cover attached when the backhoe is off comes from the area just below the Hydraulic fluid filler neck is located.
KC
