Mahindra

[adam46]

Have a 2012 4250 mahindra and the safety switch attached to the gear shifts is not allowing me to start the tractor. I have replaced the switch once and it is stopped working again. Any ideas?

 

[Mike1955]

Could we assume a fault in the original switch and the replacement also? I’m sure it’s not any physical damage you can see. Good luck Sir

 

[adam46]

I can try and replace again and maybe that will work

 

[Harry in Ky]

You have actually tested the switch (and related circuits) and know it's bad, or just assumed so because of the "no start"? If it's just a bad switch I know what I would do, but it's probably not politically correct to suggest it.

 

[bridge4]

I had this happen in my 2018 last year, I replaced it and it was right as rain. Fingers crossed you get it figured out soon.

 

[skramer360]

You have actually tested the switch (and related circuits) and know it's bad, or just assumed so because of the "no start"? If it's just a bad switch I know what I would do, but it's probably not politically correct to suggest it.

I'll say it. I'd just bypass that switch. Proceed at your own risk.