Low Cost Brush Forks
- Thread starter CompactTractorFan
- Start date
- Views: 11152
jake98
Veteran Member
- Joined
- Nov 10, 2007
- Messages
- 1,824
- Location
- Dingmans Ferry PA
- Tractor
- 53 Cub, 70's JD 410, Kioti 25hst
Now you've gone off the edge...
beppington
Elite Member
Excellent. Now attach a cross-brace 2x4 to the inside ends of those 2x4's, inside the bucket, to connect the "teeth" together & help them resist moving side-to-side (rotating around your clamp).
Oh, and cut the ends of the "teeth" so they're points! :thumbsup:
Oh, and cut the ends of the "teeth" so they're points! :thumbsup:
OP
CompactTractorFan
Super Member
OP
CompactTractorFan
Super Member
I was thinking of bracing it somehow...I must say...For light use, they work pretty good....:thumbsup:
I think Jake98 is just jealous he didn't think of doing that. :laughing: 
If you moved them out to the ends of the bucket so they are against the sides then put a cross brace at the rear they would be pretty well locked into position. You could also add a third fork in the middle for smaller branches.
If you moved them out to the ends of the bucket so they are against the sides then put a cross brace at the rear they would be pretty well locked into position. You could also add a third fork in the middle for smaller branches.
OP
CompactTractorFan
Super Member
I think Jake98 is just jealous he didn't think of doing that. :laughing:
If you moved them out to the ends of the bucket so they are against the sides then put a cross brace at the rear they would be pretty well locked into position. You could also add a third fork in the middle for smaller branches.
Yeah, probably.
I'll have to try putting in a brace. I have a couple more 2x4's...beppington
Elite Member
OP
CompactTractorFan
Super Member
Hey, thanks! I'll have to admit, I was a little confused. I'll probably built that later today. :thumbsup:
That's the idea but I'd move the two outside ones out each way till they are against the sides of the bucket like I said in my previous post. By doing that and adding the back brace like you put in your sketch, you will really lock the forks into position.
