Loader bucket question (2015)

[driver444]

Just wondering if a 60inch bucket from a 2615 with ML106 loader will fit onto a 2015 with the ML104 loader. Basically, is the arm spacing, and pin size the same? Or is a little welding gonna be in order?

I'm not worried about overloading the front axle, or making the tractor unstable. I just have alot of mulch work coming up, and that extra foot of bucket would be somewhat of a timesaver. It hardly weighs anything. Plus, I have no intention of messing with pressure settings.

I'd keep the 48 inch for the dirt work. It only takes a minute to change them.

 

[LAWALLSTRACTOR]

I am pretty sure the spacing is the same, I will check tomorrow.

 

[driver444]

Thanks,

I know it looked pretty close at a glance, but it's not unlike manufacturers to make something "just a little different" for this reason.

I'll keep my fingers crossed.

 

[RedRiver]

It should work..............according to my measurements the bucket is 43 1/4" outside to outside and 36 3/4" inside to inside.

 

[driver444]

Awesome! That's what I wanted to hear. Thanks.

 

[rback33]

Yes it will work. No Question.

 

[wallace]

So does the skid steer style quick tach

 

[rback33]

So does the skid steer style quick tach

106 does not have the skid steer QA...

 

[keen99]

My local dealer said the 106 (and 105) QA /is/ the bobcat style QA now, same as the ML111.

Any other dealers that can confirm that?

 

[LAWALLSTRACTOR]

Yes the q/tach will fit but its extra weight will take up a pretty good percentage of your lifting capacity. I believe that is why Mahindra doesn't list the quick/tach for the ML 106 and smaller, even though the q/tach will fit on the loaders.