Alan O
New member
I have a 2005 nh tz24da. The front rim is 8.inch. can I put a 10 inch rim on it without causing damage? I can't find r4 in 8 inch .thanks for any info
larger front rim
- Thread starter Alan O
- Start date
- Views: 1134
Gary Fowler
Super Star Member
- Joined
- Jun 23, 2008
- Messages
- 11,998
- Location
- Bismarck Arkansas
- Tractor
- 2009 Kubota RTV 900, 2009 Kubota B26 TLB & 2010 model LS P7010
The width of the tire is of no concern as long as there is proper clearance. You have to measure the outside dimension. It has to be really close to the one you are replacing or the ratio of front /rear drive is going to be off.
I would pull a string around the 8" tire and compare the length to the 10". If it is within an inch or two I think you would be ok. The ratio is designed so that the front tires run a little faster than the rear so they are always pulling forward a bit on the rear which is one of the reasons why the fronts wear faster than the rears.
I would pull a string around the 8" tire and compare the length to the 10". If it is within an inch or two I think you would be ok. The ratio is designed so that the front tires run a little faster than the rear so they are always pulling forward a bit on the rear which is one of the reasons why the fronts wear faster than the rears.
