Kubota wheel and loader nut torque.

[pokey1416]

FYI check your ZT lug nuts also - found mine to be below torque specs.

 

[scootr]

Excuse my ignorance but what are ZT lugs... I mean yes, zero tolerance but where are they thanks?
I got those torque sticks, I'm ready to try.

 

[Gator6x4]

Excuse my ignorance but what are ZT lugs... I mean yes, zero tolerance but where are they thanks?
I got those torque sticks, I'm ready to try.

I didn’t know either so I looked it up. I don’t think your torque sticks were designed for use with novelty items.

 

[timbatrader]

Back the the question asked If your lug nuts come loose by them selves it is a sign that the stud thread has been damaged some time in the past you will never keep it tight from now on if you don't replace the damaged studs which is quite easy you will at some point damage wheel once the holes in the wheel become oval the repair becomes much more complicated and expensive

 

[notaz3]

I will run away from any tire place that doesn't understand the concept of torque wrench. I've seen a few studs sheered off from "mechanics" using impact guns.

 

[5030]

I'll run them down with my impact set on low impact and then finish with a torque wrench in a criss cross pattern.

 

[bigtiller]

Excuse my ignorance but what are ZT lugs... I mean yes, zero tolerance but where are they thanks?
I got those torque sticks, I'm ready to try.

I don't know either and I'm not wasting my time trying to figure it out.

If the author can't take the time to type his words, I simply skip down to the next post.

 

[4570Man]

I don't know either and I'm not wasting my time trying to figure it out.

If the author can't take the time to type his words, I simply skip down to the next post.

Zero turn mower.

 

[bigtiller]

Zero turn mower.

That was my first guess also.

 

[Gator6x4]

Zero turn mower.

Why don't you do like I did and Google ZT Lug Nuts. I don't think you will find a reference to a Zero Turn Mower.