I recently replaced a hose on the control valve and when I started it back up the 3 point wont raise. When I leave the 3 point hitch lever in the lift position and curl the bucket it will raise. Is air in the system? Any help would be appreciated.
Kubota M5700 3 point hitch wont go up
- Thread starter az6930
- Start date
- Views: 5807
-
- Tags
- kubota m5700
J_J
Super Star Member
- Joined
- Sep 6, 2003
- Messages
- 18,952
- Location
- JACKSONVILLE, FL
- Tractor
- Power-Trac 1445, KUBOTA B-9200HST
Put a gage in the system and check your pressure.
On the control valve(joystick valve) I see the four line that run to my bucket and loader arm cylinders. There are 3 more lines on the valve one is labeled P, one is T, and one is BY. I assume that P is pump pressure, T is tank and BY goes to my 3 point. Does this sound right?
Stonehaller
Platinum Member
Sounds like you might have the tank and power beyond lines swapped.
kennyd
Advertiser
Yes, that is 100% correct. The BY stand for "beyond" or "power beyond", it job is to feed the next valve in the sreies-in your case the 3PH which is most common. What line did you replace? Did you have only the one disconnected?