John Deere 2520 Diverter Kit

[nate_m]

Thanks for the info.
That was kinda the answer I was expecting but I was hoping for something else.

So...
What a guy would need is

• a (3 way?) solenoid valve for each of the 4 hyd lines that leave the DSCV en-route to the FEL
• a toggle switch to fire the solenoid valves

When you hit the switch, hydraulic fluid would be diverted from the FEL to the TNT (or whatever) thus allowing you to use the joystick on the factory DSCV valve.

Anybody know of at 12 Volt solenoid stack that could be used for this setup?

If the parts are available, this would be an alternative to adding a new manual valve stack with new control levers for TNT (or whatever) functions.

 

[nate_m]

Actually, a little more research and I found the answer to my question.

I found this post from kennyd http://www.tractorbynet.com/forums/customization/48310-added-remote-fel.html

I think that by ganging two of these valves together, I could use the factory joystick to control TNT cylinders, rear remotes, etc.

All it takes is a dollar and a dream...