John Deere 1600 WAM Mower
- Thread starter chuckbuck
- Start date
- Views: 3009
Scooby074
Super Member
Best to run it wide open. AKA 3000RPM+
Increasing blade speed isnt practical beyond full engine speed. You'd be getting into changing pulley sizes and all that stuff.
Increasing blade speed isnt practical beyond full engine speed. You'd be getting into changing pulley sizes and all that stuff.
Gowfster
Member
- Joined
- Jul 4, 2005
- Messages
- 47
- Location
- Tioga County, NY
- Tractor
- JD445, Ferris is3200 x2, LS4047, JD 1600 WAM, Kubota RTV
Anyone out there with a wobbly wam steering wheel? I opened mine up and it isn’t at all obvious what’s wrong... been this way since brand new, but almost looks like a bushing at the top of the hydraulic control shaft was not installed? But not sure how it is supposed to look. It isn’t rotational slop, just north south east west... up down is tight, and turning is tight... thoughts?
Gowfster
Member
- Joined
- Jul 4, 2005
- Messages
- 47
- Location
- Tioga County, NY
- Tractor
- JD445, Ferris is3200 x2, LS4047, JD 1600 WAM, Kubota RTV
Another oddity.. when New the decks spun right up... now it can take a few seconds where you think they aren’t going to, but they always do, just seems to take longer before they start... not sure if it’s a pressure thing? Seems to mow fine.
