international674
New member
i started my 674 the other morning and when i put it in to reverse it didnt move. so i tried the rest of the ranges and found out low range wouldnt work as well. high range works perfect. any help on what this might be??
international 674 not going in to gear
- Thread starter international674
- Start date
- Views: 7280
D7E
Veteran Member
- Joined
- May 10, 2006
- Messages
- 2,267
- Location
- manitoba
- Tractor
- Versatile 895 Versatile 876 Ford TW20 Ford TW5 MF 3505 FWA MF 390 FWA Ford 7600 Fiat 766 FWA JD 2030 MF 165 MF 35 Fordson major x 3 CAT 416 b Backhoe Case 580 b backhoe MF
It is common for the hi/lo/reverse linkage to jam when worn . Mine did it quite often as it had a loader , I cant remember without looking at it but you just have to tap the linkage in the right place with a hammer or something .
DLTTrekkers
Veteran Member
Is your gearlever in neutral or in hi ?
OP
international674
New member
DLTTrekkers
Veteran Member
When lever is in hi the tractor moves . Do it move aswell when in neutral ?
OP
international674
New member
no tractor comes out of gear when i put it in neutral
DLTTrekkers
Veteran Member
Rollpin inside broken
OP
international674
New member
is it a big job to do?
DLTTrekkers
Veteran Member
First ! You have a quadrant with a slot fitted to that shaft sticking out of the gearbox where that bush was sticky . Do that quadrant rotates a lot ? That will mix-up your gears and be a indication of a broken roll pin ! Do that quadrant rotates a lot ?