hydraulics not working

[aam730]

Can anyone tell me why the hydraulics stop working?
I have nothing at all and no sign that there was something wrong, just stopped !!! From what I understand if the pump is going I would see some signs of it slowing lift on the bucket or some kind of hesitation, but nothing !!!

Thanks,
Tony

 

[oldnslo]

Totally stopped working would point towards pump not running. Did a drive coupling come loose, splines wear, key come out etc..

 

[aam730]

no nothing at all, that,s why it makes no sense

 

[Leejohn]

Reread post 2 and pull pump take a look at the pump shaft. also check oil level 1st.

 

[geezer32095]

I had similar problem with my ford 1510 3pt.. I would bleed a line then it would work again for a while then suddenly nothing. I ifgured it was sucking air someplace.. Replaced all the o rings, filter, oil was ok, etc etc then noticed that the pump was getting quite hot to the touch.. Replaced it with a new/used one all is fine.. There was no warning just an intermitent stopping.