Hydraulic PSI (for implement) on CK35

[rjpotts]

Anyone know what the max PSI is for hydraulic output on a CK35? I'm planning to build an implement that will use hydraulic pressure from one of the rear ports, to size the cylinder bore correctly I need to know what PSI I'm dealing with. I looked in the owners manual but it only specifies volume, not PSI.

 

[Bearsixty7]

Seems like most CUT and SCUT are around 2500psi

https://www.kioti.com/wp-content/uploads/2018/03/US-LIT-CK10SE-ALL2-1-2020.pdf

Says loader relief is 2560. not sure that's the same model it jumped to.

 

[Headwrench]

It's not that expensive to get a hydraulic gauge and QD end, plug it into your port and find out. Then you'll have a test tool :}