hottubbrad
New member
- Joined
- Oct 29, 2007
- Messages
- 20
There is a hydraulic block on the RH side of my L4310 near the foot step which has a small screw which needs to be turned from the horizontal position to the vertical position when the front end loader is attached.
Mine is rusted as there has never been a loader attached and I am installing a brand new Kubota model. (2003 tractor)
I have WD 40 and tried an impact driver (gently) and it doesn't budge.
I have tried both directions of turning.
Any ideas which way the screw needs to be turned (clockwise or counter clockwise). It is horizontal now.
I don't necessarily want to beat the heck out of it until I know exactly which way it should be turning.
Also, there is a snap ring on the screw. If I remove this would it help???
Mine is rusted as there has never been a loader attached and I am installing a brand new Kubota model. (2003 tractor)
I have WD 40 and tried an impact driver (gently) and it doesn't budge.
I have tried both directions of turning.
Any ideas which way the screw needs to be turned (clockwise or counter clockwise). It is horizontal now.
I don't necessarily want to beat the heck out of it until I know exactly which way it should be turning.
Also, there is a snap ring on the screw. If I remove this would it help???
