How to Replace Studs in Bro-Tek Wheel Spacers?

[HeLa]

I went to remove a rear wheel from my BX the other day and a wheel stud in my Bro-Tek wheel spacer snapped as soon as I applied pressure.

Anyone know:

1. Can I simply press these from the front side?
3. Where can I find a replacement?

 

[bill18163]

It does look like a press fit. It should just press out. Did you try to get a replacement stud from Bro-Tek?

 

[TractorNH]

That looks like a grade 8 stud. How long was the pipe you had on the breaker bar?

I would suggest emailing Richard at Bro-Tek to see if you can get a new stud.

 

[mrmikey]

61-176 by DORMAN - WHEEL STUD maybe????..............Mike

 

[dodge man]

I've put them in vehicles before. You should be able to drive the old one out and I usually pull the new one in. I usually just use a nut and keep tightening it to pull it tight, sometimes you may have to put a space under it so the lug nut has something to pull against.

 

[HeLa]

That looks like a grade 8 stud. How long was the pipe you had on the breaker bar?

ha! i'm guessing a manufacturing defect in the stud. it snapped instantly when applying pressure with a standard 1/2" ratchet.

 

[HeLa]

I would suggest emailing Richard at Bro-Tek to see if you can get a new stud.

thanks. i sent him a note in parallel. figured i'd ask here in the meanwhile - always lots of experience on the forum.

 

[RickB]

Drive the new one in, don’t pull it.

 

[mikester]

Try your local auto-parts store. Bring in the spacer and have them match up your stud.

 

[dragoneggs]

Following along... See what Richard at Bro Tek says before you take other action. I have 2in spacers on the back and 1.25in on the front of my BX. Great products in my opinion.