Home made tractor cab

Jmsossi · Nov 15, 2013

Hi guy's
This is my first post to this forum.
I purchased a kubota gr2120 tractor and built a cab for it and thought I would post it here to give you some ideas on building your own.
Here are some links. Kubota gr2120 cab - YouTube
Tractor Cab Photos by joeshop | Photobucket
Hope you enjoy

Relic · Nov 15, 2013

nice looking cab you built

Travelover · Nov 15, 2013

Beautiful work.

nsmithnd · Nov 15, 2013

Looks like it will be nice and cozy!!
Got to spend 3 years at KI Sawyer (never made it up to your neck of the woods).
Arrived there on a Friday in mid-December and there was still green grass, thought the "snow" stories must have been someones imagination.
It started snowing Saturday and by Monday morning there was 32" on the ground, as I recall the average was 120" or so.
Can only imagine the amount of snow you get... 150+ inches?

Jmsossi · Nov 15, 2013

We get anywhere from 180 in. To 400 in of snow per year with about an average around 250 to 300
So that will give the little kubota a workout &#55357;&#56832;

msb1766 · Nov 15, 2013

That is a great looking cab that you made!!!

Dr Dave · Nov 15, 2013

Nice job on the cab and the accessories. Were did you get the wiper motor and wiper arm? I would like to install one on my skid steer. I found motors at surplus center, but they do not list a wiper arm to fit.

Dave

Jasonc87 · Nov 16, 2013

I really like that whole setup! Snow removal isn't usually pleasurable but that cab with a heater and a wiper should make it a whole lot closer to being! I have the same question... Where did you find the wiper set up as well as the heater core? Does the heater core have a fan behind it? One last question I see how you're getting the coolant to the core but how do you return it?

Jmsossi · Nov 16, 2013

Hi Jason
I purchased the wiper motor at Surplus Center and bought the wiper arm from my local auto parts store . The wiper arm is a universal with adjustable length, the shaft on the motor is a common size.
The heater was purchased at https://www.tractorpartsasap.com/Auxiliary_Heater_p/111417.htm yes it has a 2 speed fan. I tapped into the thermostat housing for the supply to the core it is British pipe thread but standard pipe is close in size and works just fine. As for the return to the engine I cut the lower rad hose and made a tee to install in it. Heater works great only takes 5 min to get heat when cold. Hope that helps.