Harbor Freight Tools that don't suck

   / Harbor Freight Tools that don't suck #5,771  
Yes. Just be clear that they are not going to support a 4x8 foot sheet of 12 gauge steel on edge. A foot or two of vertical height I would not be concerned about at all when using about one every foot or so along the base. Just use more of them if you have something a bit taller but they really are not designed to hold stuff that you couldn't easily hold in place with one finger if you were lucky enough to have three arms.

You have an ingenious way of cleaning out all of the metal fileings that get attached to them?
 
   / Harbor Freight Tools that don't suck #5,773  
Those magnets might hold a smooth bar the same weight as the rebar. The ridges on the rebar prevent the magnet from getting a good grip.

Bruce
 
   / Harbor Freight Tools that don't suck #5,777  
   / Harbor Freight Tools that don't suck #5,778  
Plastic wrap.

Is that to remove the filings or to prevent them from attaching??? I can see it is a great idea to prevent filings from attaching but don't see how it would remove them.
 
   / Harbor Freight Tools that don't suck #5,779  
Remove the filings by holding a short strip of duct tape on your finger, adhesive out, then pressing the filings.

Bruce
 
   / Harbor Freight Tools that don't suck #5,780  
I was thinking of getting these for the purpose you describe. In your opinion they are decent tools for position of supported metal?
They work great for me used as IT previously mentioned.
 

Tractor & Equipment Auctions

2018 Infiniti QX30 Premium SUV (A50324)
2018 Infiniti QX30...
2019 MACK GR64F TANDEM AXLE CEMENT MIXER TRUCK (A52577)
2019 MACK GR64F...
2006 CHEVROLET SILVERADO 4X4 PICKUP TRUCK (A51222)
2006 CHEVROLET...
2025 25ft. 800Amp Extra HD Booster Cables (A51692)
2025 25ft. 800Amp...
6' AGT Skidloader Rotary Mower (A50774)
6' AGT Skidloader...
Skid Steer (A51691)
Skid Steer (A51691)
 
Top