Half scale replica of a John Deere H

bakerg · Apr 19, 2015

Projected got pushed to the side with us moving and my mother passing away, hope I will now get sometime to work on it again.
Got some work done on the steering shaft, installed grease fitting & square up and welded the socket extension in place.

Thomas · Apr 19, 2015

Glad its getting back to normal for you

...keep the updates coming on the project.

bakerg · Jun 28, 2015

Got the steering shaft welded to the pedestal. mounted a gas tank and got the little bugger running for the first time in about 20 yrs. A lot of smoking at first but that has seemed to have gone away. Even took it for a drive through the subdivision. Here a couple of really short videos of the engine running. Maybe I can find someone to tape me driving it around.
You can see the flywheel turn in this video.

bakerg · Jun 28, 2015

You can see the clutch pulley turning a little here, it is just held on with a clamp right now.

Larro Darro · Jun 28, 2015

It's looking good.

bakerg · Jun 28, 2015

Here's a video of me driving it around the back yard. Using a screwdriver to tighten the belt pulley as I do not have the hand clutch arm installed yet. Figuring out how the hand clutch is going to move the pulley into position will be a challenge.

Larro Darro · Jun 28, 2015

I'm not sure the dog likes it as much as you do

spencerpearson22 · Sep 27, 2015

so did the thread die out. i was enjoying this. and how does the rollers turn on the sides. is that a pto or do they just spin when your in gear.

bakerg · Sep 27, 2015

Haven't had much time to work on it, hope to get back to it soon. Flywheel spin through a gear box when motor turns and the roller as you call it engages when the hand clutch is engaged.