Greasing front axle

[nosaj2]

So there are two fitting on the font of the tractor along the front drive shaft. The one nearest the rear of the tractor pushed grease out after 2-3 squirts. The front one did not. Even after 4-5. Should I be expecting grease to exit somewhere?

Also my new 2515h seems to not have a zerk for the brake pedal. Is this right? Or am I just missing it.

 

[ericm979]

Can you feel grease going in?

One of my 3725's center pivot zerks did not accept grease at first. After trying with the wheels off the ground it started working, and now takes grease with the wheels on the ground.

 

[nosaj2]

Good point. I thought it was going in. But maybe I should remove the zerk and make sure.

 

[Sawyer Rob]

I ALWAYS take the weight off the front end pivot when greasing it...

SR

 

[fried1765]

I ALWAYS take the weight off the front end pivot when greasing it...

SR

Yup.....correct procedure!