Grade 8 Shear Bolt?

[etpm]

Leaving this here. May help future readers.

Attachments

• 
  1652125928627.png

  23 KB · Views: 1,333

Thanks for posting that little chart. I have seen similar when I looked for fastener strength comparisons between Metric and SAE but never bothered to save what I found. I even have a few editions of Machinery's Handbook, the earliest from 1918 and the newest from 2015 and the newest edition has the info. But now, thanks to you, I have it on my computer desktop also and this will certainly save time.
Cheers,
Eric

 

[Jerry/MT]

Thanks for the replies!

Can anybody tell me the size of the bolt that I need?

8.8 mm in diameter. It's a metric bolt. As far as length, does your manual specify a length? You'll need an 8.8 mm nut(s) also.

 

[stumblinhorse]

I think there is some confusion here. 8.8 is the grade nothing to do with diameter, per se. Metric shear bolt size will be something like M10x50 “property class” 8.8.

 

[WranglerX]

8.8 mm in diameter. It's a metric bolt. As far as length, does your manual specify a length? You'll need an 8.8 mm nut(s) also.

8.8 is a grade of bolt... 120,000 PSI shear not a diameter.... Metric bolts are generally even numbers as 6mm, 8mm, 10mm, 12mm and so on....

 

[Snobdds]

I think there is some confusion here. 8.8 is the grade nothing to do with diameter, per se. Metric shear bolt size will be something like M10x50 “property class” 8.8.

This is the info to persuse. It probably going to be m8 or m10 by 1.0 or 1.25 thread pitch. Then figure out the length. 20mm, 30mm. Etc.

Stores will sell them denoted as M10x1.0x20.

 

[LD1]

Did you ever figure out the bolt size?

 

[jwmorris]

What is the diameter of the hole it goes in?

 

[Jerry/MT]

I think there is some confusion here. 8.8 is the grade nothing to do with diameter, per se. Metric shear bolt size will be something like M10x50 “property class” 8.8.

I stand corrected!

 

[madtowneast]

I found the new model of the driveshaft part list:

https://patsdriveline.com/wp-content/uploads/2020/02/comer_PTO_Driveshafts.pdf

On page 65

it is supposed to be an M8 or M10

the diameter is ~5/8 inch, so M10

 

[KWentling]

I found the new model of the driveshaft part list:

https://patsdriveline.com/wp-content/uploads/2020/02/comer_PTO_Driveshafts.pdf

On page 65

it is supposed to be an M8 or M10

the diameter is ~5/8 inch, so M10

I assume you meant 3/8 inch, as 5/8 inch would be M16.