47F and cloudy @ 12:30, calling for a high of 48F for the day. Low this morning was 32.8F.
Got large foam board panel glued up and braced on west wall underneath window yesterday first thing.
Cut a small piece of foam board to fill in a section next to the window on the west wall.
Then a little more work on the short section of remaining studs for the south wall to correct a measurement error.
Got that section plumbed up and nailed into the joists overhead, into an interior block wall, and into the concrete floor below.
Drilled a couple more holes to pass the romex through, then finished up adding electrical boxes and got the last 2 electrical outlets installed on that section.
After that worked on filling in the cavities between the studs with unfaced R-11 fiberglass. Got 5 of those done.
Was around 00:30 at that point so I knocked off for the day.
Brought RockBox up to recharge it but forgot to the plug it in ...
Agenda for today:
Cut and piece in a small bare area on the south wall around HVAC ducting.
Have a couple more short pieces of 2 x 4 to cut and install on that last section of studs on the south wall.
Cut and install more unfaced fiberglass in between studs.
Glue up the small piece of foam board to fill in the section next to the window on the west wall and get that installed.
Down to only four 2 x 4 x 8's in garage so maybe take the Kubota over to the barn and grab another dozen or so of those and get them stowed away in the garage while the sun is out.
Beyond that just see what else comes up.
Still no email with proposal from the well driller in Mansfield ...
Hope everyone is having a decent Wednesday ...
