Good morning!!!!

   / Good morning!!!! #22,681  
57 and Cloudy with a few sprinkles,turning sunny later with a high temp of 72.Its a cool one this Morning,a long sleeve Shirt feels good.
 
Last edited:
   / Good morning!!!! #22,682  
Good morning all. 66F this morning, forecast for 73F and sunny wind 15 mph. Lawn mowing, paint drying and bike riding on the agenda today.
 
   / Good morning!!!! #22,683  
68F and .33 inches rain last 24 hours that's 91.02 inches ytd.
Have to go to town later for stuff for 4th of July gather, might as well get some metric nuts and bolts for my last chair..

Be safe
Have a great day.

David Sent from my iPad Air using TractorByNet
 
   / Good morning!!!! #22,684  
96 degrees out, drip, drip
but the blades sharpened great using a Dewalt hand grinder and some elbow grease.
right near us was the obvious answer to our backup/jackstand/last resort needs, and they rolled right up to the spot
like they were out for a walk.

whole thing was fifteen minutes from start of tying up to dropping it down. And then fifteen minutes of exasperation and sweaty despair
when the miserable pto hitch spline refused to line up. I finally had to do what worked last time, get down on my back under the whole thing and work from below.
it's all lubed...they really need to design a better mousetrap here. so half the time to sharpen the blades and half the time fighting with the pto slide connection that requires at least three hands to hold the retaining ring in while keeping level and providing substantial forward motion. It didn't cooperate today; other days it slides right on.

the straps are rated for double the entire mower's weight so wasn't concerned, but the round wood chocks were worth taking a picture of.
see, it did happen...:D
 

Attachments

  • DSCN0298.JPG
    DSCN0298.JPG
    855.9 KB · Views: 122
  • DSCN0299.JPG
    DSCN0299.JPG
    887.9 KB · Views: 113
  • DSCN0300.JPG
    DSCN0300.JPG
    880.4 KB · Views: 102
   / Good morning!!!! #22,685  
Well, table is in service for the 4th, but when I have time, I'll likely sand and do another coat or two of urethane.
For those interested, table is about 96x89, 113 at diagonal.
Lazy Susan is a tad small, but only paid $50 for the glass so works for now.
Like the new chairs, good match
image-623701103.jpg
I 'd guess a chair at each corner and 16 would still be comfy.
David
Sent from my iPad Air using TractorByNet
 
   / Good morning!!!! #22,686  
Well, table is in service for the 4th, but when I have time, I'll likely sand and do another coat or two of urethane.
For those interested, table is about 96x89, 113 at diagonal.
Lazy Susan is a tad small, but only paid $50 for the glass so works for now.
Like the new chairs, good match
View attachment 381420
I 'd guess a chair at each corner and 16 would still be comfy.
David
Sent from my iPad Air using TractorByNet
Looks great David.
 
   / Good morning!!!! #22,687  
Drew, are you ready for your 1st hurricane at your new place? I know you aren't in it yet.
 
   / Good morning!!!! #22,688  
Drew, are you ready for your 1st hurricane at your new place? I know you aren't in it yet.

sure going to find out. There are no large trees near the house; that's a plus, and one of the first things I'm doing is putting in a backup gen.
the siding on the house is pretty tired, not sure how it would last. I'm probably eight miles north of the Pamlico, and intentionally not in a flood plain, so
I think the water risk isn't bad. No basement in this house; need to find a safe hidey hole. No question, I will be in the path of the typical NorEaster, but then I always have been, so....
 
   / Good morning!!!! #22,689  
Thanks Kyle
8 for dinner last night, will be 10 tonight, Friday it should be full LOL

David Sent from my iPad Air using TractorByNet
 
   / Good morning!!!! #22,690  
Drew, I think if there was much vulnerability you would have seen evidence of past storms.

David Sent from my iPad Air using TractorByNet
 

Tractor & Equipment Auctions

2013 WILCO MACHINE & FAB INC. WILCO MACHINE & FAB INC. (A50854)
2013 WILCO MACHINE...
2012 FORD F-650 (A50854)
2012 FORD F-650...
1989 Freightliner FLD120 (NEW CAT 3406A, NEW REAR ENDS, CLUTCH) (A50397)
1989 Freightliner...
2007 Ingersoll Rand P185WJD Towable Diesel Air Compressor (A49461)
2007 Ingersoll...
2015 Ford Explorer AWD SUV (A50324)
2015 Ford Explorer...
CUSTOM TRAILER (A51242)
CUSTOM TRAILER...
 
Top