Gaining oil

[Mike1955]

Sometimes we get a bit complacent. We are all led to believe it’s diesel. But how is you hydraulic oil level? If by chance that’s what’s getting into your crankcase your sump may be getting low. Just thinking without any outside influence. Good luck mann

 

[joecdeere]

Have you checked the diaphragm in the mechanical fuel pump?

 

[coast40]

Have you checked the diaphragm in the mechanical fuel pump?

I have a similar issue on my Bobcat 331's Kubota 2203. Getting a new lift pump first. $20-50 for a fried rice version NO!, $120-135 for genuine Kubota YES!, plus s&h. $216 from Mess... My hydraulic pump is attached with a bell-housing with no apparent way for hyd oil to get into crankcase.

 

[Little Red Tractor]

Draw an oil sample and get it analyzed. That will tell you what's in the oil so you don't have to guess.

I think that's the ONLY way to be sure you know where to go looking.

 

[bmaverick]

B20 Kubota TLB. It was gaining probably an inch on the dipstick in an hour. I replaced the fuel pump with an oem from Coleman's Kubota. Still gaining the same. Next I removed the injection pump and took it apart and didn't see anything wrong with it, just cleaned and reassembled it. Put it back on and used it for two or three hours and it didn't gain at all. A couple days later I used it and it gained about half inch in probably three hours. It's a cast iron Diesel Kiki pump. Any suggestions on what to do next would be greatly appreciated.

If it looks clean, bottle it and make more. With the price of oil these days, you will have the magic oil making machine as an oil tycoon.