Frontier RB2060L Owners

[Timberman444]

I thinking about buying the 5' rear blade and have a few questions about it, whats the total height moldboard+cutting edge, and when the blade is angled all the way (either side) how wide is the width of the cut?

 

[chadrotter]

One work on the RB2060L, DONT. It is a piece of crap. In one season I had bent that toy blade enough that I needed to back up to a tree and strike the outboard ends so that I wasn't pulling a V-plow through the snow.
-The curvature of the moldboard was almost eliminated in one heavy winter
-The pivot pin has no nylon lock-nut or bearing style castle nut, so it is constantly working itself loose with regular use
-The angle establishment is wheenie and loads applied easily bend the cheesy pin

For your money your way better off going with a Land Pride RB15.

 

[JiminGa]

One work on the RB2060L, DONT. It is a piece of crap. In one season I had bent that toy blade enough that I needed to back up to a tree and strike the outboard ends so that I wasn't pulling a V-plow through the snow.
-The curvature of the moldboard was almost eliminated in one heavy winter
-The pivot pin has no nylon lock-nut or bearing style castle nut, so it is constantly working itself loose with regular use
-The angle establishment is wheenie and loads applied easily bend the cheesy pin

For your money your way better off going with a Land Pride RB15.

can you please let us know what you were pulling with as to determine if the blade in question was destroyed due to poor engineering or maybe outmatched. the L designator is specifically for subcut's with limited lift height which are generally not powerful enough to tear them up.

 

[chadrotter]

A 2305 JD was all that pulled it.

 

[dirtworksequip]

Chad, not to be critical of you...................but maybe you should take it a little easier on your equipment. Bent loader mounts and bent rear blade. Something tells me you are asking too much of your tractor and attachments.

Sincerely, Dirt

 

[JiminGa]

Chad, not to be critical of you...................but maybe you should take it a little easier on your equipment. Bent loader mounts and bent rear blade. Something tells me you are asking too much of your tractor and attachments.

Sincerely, Dirt

I was thinking the exact same thing.

 

[Staghead]

I have been using the RB2060L on my 2520. I use it for snow removal and dirt/gravel. I don't have the measurements, but I do wish I would have gone with a bigger blade. No problems with anything bending or breaking at all, but just to have the extra reach. It was just such a better deal (dealer had in stock trying to sell) than ordering a bigger one. So from that perspective I'm satisfied as it does exactly what I need it to do.