Free Technical Support for Jinma?

[DELJEN]

Even the phone call is free 866-533-5536. Free technical support whether or not you purchased your tractor from us, our technicians are here to help you with your Jinma or other Jinma built tractor. Does it get any better than this? Ryan @ Team Deljen

 

[MarkNHow]

Ryan,

That is a very generous offer. I would like to extend my thanks to you and your staff.

Mark H

 

[billbill1]

Ryan, this is great, thank you.

Bill Williams

 

[vfss]

hi Ryan I have a Jimna 304 but can not get three point hitch to raise my mower, have moved the two handles on my right side and with out load it will lift but loaded it wont lift, am I missing another regulation of the hydraulic fluids?
victor
vsolorzano@empaquessanlucas.com

 

[Bob Rooks]

Even the phone call is free 866-533-5536. Free technical support whether or not you purchased your tractor from us, our technicians are here to help you with your Jinma or other Jinma built tractor. Does it get any better than this? Ryan @ Team Deljen

Not always one to look a gift horse in the mouth, but this popped up out of the blue.
Exactly what/where is Delgen, and who is Ryan? What is their relationship with Jinma? Qualifications?
Just curious.

 

[greg_g]

It's Ryan Delaney, and DelGen is a dealership up in Wisconsin. His is the outfit that originally developed the gear reduction starter to replace the QD100C3 (and equivalent). Good folks to work with.

//greg//

 

[Bob Rooks]

It's Ryan Delaney, and DelGen is a dealership up in Wisconsin. His is the outfit that originally developed the gear reduction starter to replace the QD100C3 (and equivalent). Good folks to work with.

//greg//

Well, that's great, why didn't he say that?

 

[greg_g]

I guess he was relying upon corporate memory.

//greg//

 

[Xfaxman]

Also the OP is from 11-29-2004!

 

[greg_g]

And me since 2003. I'm part of the corporate memory that remembers him

//greg//

 

[Bob Rooks]

Well I rember him too... now.
Apparently my corporate memory has failed.

 

[greg_g]

hi Ryan I have a Jimna 304 but can not get three point hitch to raise my mower, have moved the two handles on my right side and with out load it will lift but loaded it wont lift

Appears that Ryan’s offer of free tech support may be telephone only. If true, I’ll try to help. One of those levers is to raise/lower the rear lift. The other is for draft control. Don’t know about the JM304, but on my KM454 the outer lever was draft control. For lift control to work normally, draft control must be in the OFF position. On mine, that was in the full UP position. Not sure about your Jinma, so defer to your owner manual for specifics.

//greg//