I just bought a Foton 404 with the SL3105BT engine. This site has been great showing tricks to help with the tractor. I have changed all the fluids in the tractor except the oil in the injector pump. I found on an old page that you fill it by removing the little mushroom shaped thing on the top of the pump. I tried turning it and pulling up on it, but I could not get it to come off. How do you remove this vent to fill the pump?
sd455dan
Elite Member
- Joined
- Oct 23, 2012
- Messages
- 4,774
- Location
- North Idaho
- Tractor
- Rhino 554, Ford 550 TLB (JD X500, MTD, Gilson riding mowers) Ford 3000-Sold
If it is like some other chinese tractors it unscrews and a narrow wrench under the bell shaped top will unscrew it .
doxford jim
Veteran Member
- Joined
- Mar 29, 2007
- Messages
- 1,004
- Location
- British Columbia, Canada
- Tractor
- 1959 MF-65 sold, 2007 Jinma 554 diesel.
On my tractor the mushroom shaped vent is screwed into the top of the pump housing. In my case a 9/16" size wrench does the trick. Other pumps might vary of course, but thought I would mention it.
There should be a drain in the bottom of that pump casing to drain out the old oil. Again, on my tractor, the drain is a small bolt with a 10mm AF head. Small wrench size 10mm does the job nicely.
tractor components vary, but similar in many ways.
There should be a drain in the bottom of that pump casing to drain out the old oil. Again, on my tractor, the drain is a small bolt with a 10mm AF head. Small wrench size 10mm does the job nicely.
tractor components vary, but similar in many ways.
greg_g
Super Member
- Joined
- Dec 18, 2003
- Messages
- 6,126
- Location
- Western Kentucky
- Tractor
- JD3720 Cab, 300X loader with 4-in-1 bucket
Yeah, the mushroom shaped thing on the top is the fill vent. There should be a small drain plug on the bottom, roughly opposite the fill/vent. There's another on the rear facing end. Remove fill/vent and both plugs, drain, replace bottom plug. Pour in fresh oil through the fill/vent until it runs out the side drain. Replace side plug, replace fill vent. Done.
//greg//
//greg//
Wa11banger
Gold Member
- Joined
- Oct 20, 2013
- Messages
- 302
- Location
- Huntsville Al
- Tractor
- Foton FT404 w/Koyker 160 FEL and a Dig-It Towable Backhoe
it is how the others have stated however I would add that I was unable to remove my lowest drain plug due to interference with hard points. so I used a syringe and a small flexible fuel tube I had laying around from a chainsaw tank rebuild to finish sucking the fluid out of the bottom of the aft half of the pump.