Ford 600 hydraulics...

   / Ford 600 hydraulics... #1  

Mika75

Member
Joined
Mar 19, 2014
Messages
27
Location
Murphy,NC
Tractor
Kubota BX25D
I have a Ford 600 (640 model).

Other than converting it over to 12v negative ground, it seems to be pretty stock.

My question is about adding hydraulics. I'm not planning on adding a frontend loader but was simply wondering if the two accessible ports on the hydraulic pump, can be configured as input and output ports.

Just wondering if they can be used for anything except priming the pump itself.

I can't figure out how to attach pictures to this post.
 
   / Ford 600 hydraulics... #2  
If you want remote control hydraulics on your 640, you don't mess with the factory pump, but install an accessory manifold and control valve on the top cover by the seat:
1726077616247.png
 
   / Ford 600 hydraulics... #3  
Those are for bleeding the system or pressure testing, if you want or need additional hydraulics add the slave valve to the top of the hydraulic cover right under the front of your seat. You can get valves with one or two circuits depending on your needs.
 
   / Ford 600 hydraulics...
  • Thread Starter
#4  
I understand now. Thank you both for your responses, I very much appreciate them!
 

Tractor & Equipment Auctions

JOHN DEERE CP 770 (A53084)
JOHN DEERE CP 770...
1995 Chevrolet K2500 Pickup Truck, VIN # 1GCGK29F2SE237154 (A51572)
1995 Chevrolet...
BAUMA LIGHT TX 12 LOT NUMBER 240 (A53084)
BAUMA LIGHT TX 12...
New/Unused 7ft Stainless Steel Work Bench with 20 Drawers (A51573)
New/Unused 7ft...
2008 FORD RANGER SINGLE CAB TRUCK (A51406)
2008 FORD RANGER...
2016 FORD INTERCEPTOR (A51406)
2016 FORD...
 
Top