Soundguy
Old Timer
- Joined
- Mar 11, 2002
- Messages
- 52,424
- Location
- Central florida
- Tractor
- RK 55HC,ym1700, NH7610S, Ford 8N, 2N, NAA, 660, 850 x2, 541, 950, 941D, 951, 2000, 3000, 4000, 4600, 5000, 740, IH 'C' 'H', CUB, John Deere 'B', allis 'G', case VAC
if it's a pto seal only.. it's about 20$ for a new seal and gasket.
make sure it is not a bad bearing... with machine off.. grab shaft and see if there is in / out movement or side play. if none.. it's a realitively easy fix.. just make sure pto engagement is 'in gear' before you slide her out... and tip nose down to prevent loosing oil.
it's about a 6 m job to pull the 4 bolts, slip the shaft out, pop out split rings.. drop bearing carier off shaft/bearing.. drive out seal... seat new seal.. lube.. clean carrier, reset shadt and split rings.. clean gasket surface, add gasket, stab hole and slide home. put in 4 bolts.
make sure it is not a bad bearing... with machine off.. grab shaft and see if there is in / out movement or side play. if none.. it's a realitively easy fix.. just make sure pto engagement is 'in gear' before you slide her out... and tip nose down to prevent loosing oil.
it's about a 6 m job to pull the 4 bolts, slip the shaft out, pop out split rings.. drop bearing carier off shaft/bearing.. drive out seal... seat new seal.. lube.. clean carrier, reset shadt and split rings.. clean gasket surface, add gasket, stab hole and slide home. put in 4 bolts.
