Fixing the Box Scraper

ice12585 · Sep 25, 2013

So after backing into a stump a little too hard, and bending the crap out of the three point connection to the box scraper, I decided to make it a little stronger! The new picture is a little fuzzy sorry but it was dark by that time. Anyone else have this prop. The gray primer is just so it wont rust until I get the other side finished and get around to painting it.

schmism · Sep 25, 2013

let this be another warning to all BB users who havnt bent something while pushing (intentionally or not) with their BB.

FYI you may have moved the weekspot to your 3pt arms should another incident occur. If that's the case, i would consider the mod as not beneficial.

94BULLITT · Sep 25, 2013

I have seen them on craigslist bent there. I would add a clevis hookup to it.

oldballs · Sep 26, 2013

For a guy with "Ice's" skill that wouldn't be that hard to do. I've found that clevis hitches are easier to hook up anyway....since I don't have a quick hitch. Bending over the back of an attachment and raising the lower arms into position, allows me to slip the pins in without much trouble.