Mac25
Silver Member
Anybody ever fabricated a set of FEL shoes for snow removal on a gravel driveway?
Snow FEL shoes
- Thread starter Mac25
- Start date
- Views: 2536
smweatherman
Bronze Member
With a blade or are you using the bucket?
OP
Mac25
Silver Member
Just with the bucket. Want to fabricate something that will bolt to the bucket so that I dont have to drill any holes in the bucket.
kevin37b
Veteran Member
Curl your bucket up a little past level . This will keep it from digging in , till things freeze up a little.
oldballs
Elite Member
- Joined
- Dec 29, 2009
- Messages
- 4,478
- Location
- Kansas...USA
- Tractor
- Kubota B2620 , Case 448 , Kubota B2650
I've heard of buying the shoes that are meant for truck plows and adapting them to either a front/bucket/blade or rear blade. How you would do that without welding or bolting (drilling a hole) is beyond me.
Chilly807
Elite Member
I've done just what you were talking about, they are skids more than shoes.. they work very well, with the ramps on the front of the skids you can curl the bucket down a little to scrape as low as you want to go without getting gravel. I had to add some weld to the front of the ramps after the first season as they were starting to wear thin. Since then they haven't worn much, I guess the weld was better material.
Like Oldballs was saying, I had to drill 4 holes through the bucket on each side to attach them, then file the holes square to accept carriage bolts. The holes haven't caused me any problems in the off season.
The body is built from 1/4 plate, except for the crossbar on the back which is 3/8 I think. They bolt up through the reinforced section of the bucket so there's no worry about them tearing out. Let me know if you want more detailed pics.
The screen for the bucket makes a big difference for snow clearing, you can get almost twice as much with no spillage over the top. Lights still shine through the screen.
Sean
Like Oldballs was saying, I had to drill 4 holes through the bucket on each side to attach them, then file the holes square to accept carriage bolts. The holes haven't caused me any problems in the off season.
The body is built from 1/4 plate, except for the crossbar on the back which is 3/8 I think. They bolt up through the reinforced section of the bucket so there's no worry about them tearing out. Let me know if you want more detailed pics.
The screen for the bucket makes a big difference for snow clearing, you can get almost twice as much with no spillage over the top. Lights still shine through the screen.
Sean
Attachments
OP
Mac25
Silver Member
Was thinking about welding some type of bracket to accept the skid shoes and then using a "setscrew" method to attach to the bucket like they make for pallet forks. That way I dont have to drill the bucket.
Chilly807
Elite Member
You may find that the setscrews don't hold the skids that well, they take quite a beating compared to forks. I don't know for sure, I didn't try it that way myself.
Sean
Sean
