FEL Disconnect Process

[Duke4AZ]

I have a CUB 7194 CUT with a CC 416 FEL on the front. This is my first tractor and still learning how to operate it. It was used so did not come with a lot of instructions on operation. I need to get at the engine and the FEL presents a bit of an obstical. One of the areas I am not knowledgable on is removing the FEL from the tractor. It appears to have all of the quick disconnect features, mechanical and hydraulic, which I can pretty much figure out, but the actual mechanics of getting the FEL supported and the tractor out from under it are where I am lacking knowledge. If any of you experienced tractor guys could give a nubee some points and instruction, it would be greatly appreciated.

I am attaching some photos to help with the process. One photo inparticluar shows the stand weldment . . . without any actual welding on it . . . and while I know it plays into the process, I am not sure exactly how.

Thanks in advance,
Duke