Loader Factory SSQA bracket for MT125 and MT122 LL1101 loader

[mxr662]

I decided to go a different direction and ordered the weld on quick-tach adapters after being inspired by this post.

 

[mxr662]

@mslisaj

On your quick-tach, are these bushings still used, or are the side plates closer together? Looking at your photos, I do not see the bushings.

Nevermind, I see in your last picture no large bushings.

 

[sneyeper]

Btw, I took all this info about a month ago and went to a NH dealer about 2 hours away and had everything to pick up 5 days later. I have an LL1101 and everything pinned on perfectly and now the geometry is perfect when dumping ... Unlike the SSQA that the dealer installed on it where I purchased it. Side note, I also still have been pinning/unpinning the stock bucket, so I picked up an SSQA bucket too. Stock bucket for sale in WV ... Hahahaha!

 

[martellsons]

Btw, I took all this info about a month ago and went to a NH dealer about 2 hours away and had everything to pick up 5 days later. I have an LL1101 and everything pinned on perfectly and now the geometry is perfect when dumping ... Unlike the SSQA that the dealer installed on it where I purchased it. Side note, I also still have been pinning/unpinning the stock bucket, so I picked up an SSQA bucket too. Stock bucket for sale in WV ... Hahahaha!

You say the SSQA didnt work with the stock bucket? what year and version of that bucket did you have we have a mt125 with what I believe is set up with the ls version of quick attach bucket? will that work with the above new holland ssqa attachment?