Extra Hyd. Valve Kit

[MapleLeafFarmer]

for the Kubota experts out there... I am looking to add a hyd. bucket grapple to my little B2620.

My B2620 came from Kubota with a front bucket and a rear frame mounted Backhoe. Plus some other goodies.

The question I have is about working the cyl. on the bucket grapple.

When I remove the Backhoe I disconnect the 2 hyd. lines from the backhoe and connect them together. The tractor then operates correctly with no backhoe attached. So with the backhoe removed, should I be able to use these lines that would normally run the backhoe when connected to run the cyl on the bucket grapple by adding a valve and hyd. lines to the front of the tractor?

thanks in advance

 

[samofsweden]

for the Kubota experts out there... I am looking to add a hyd. bucket grapple to my little B2620.

My B2620 came from Kubota with a front bucket and a rear frame mounted Backhoe. Plus some other goodies.

The question I have is about working the cyl. on the bucket grapple.

When I remove the Backhoe I disconnect the 2 hyd. lines from the backhoe and connect them together. The tractor then operates correctly with no backhoe attached. So with the backhoe removed, should I be able to use these lines that would normally run the backhoe when connected to run the cyl on the bucket grapple by adding a valve and hyd. lines to the front of the tractor?

thanks in advance

Hi Boakley,
Please check my ealier thread, it may help you

http://www.tractorbynet.com/forums/...ng/183707-extra-hydralic-bx24.html?highlight=

Good luck
/Sam