Very new here and I’m wondering if I can get some help from the wise people that I’ve been reading here I have a John Deere E110 lawnmower tractor I changed the battery from 300 to 350 cold cranking amps change the starter change the solenoid and the ignition switch when I turn it on The positive cable going to the solenoid gets extremely hot. It’ll turn over only once it’s extremely clean and I’m a little bit at my wits end. I had read somewhere by increasing the amps if the cables are not rated then they would get hot. It doesn’t make sense to me.
Electric John Deere e110
- Thread starter Johnchap
- Start date
- Views: 631
-
- Tags
- deere john deere
Roadworthy
Elite Member
Generally if a cable gets extremely hot it's either a loose connection or the wire is too small. If you've not changed the wire suspect a loose connection or corrosion. As far as the cold cranking amps, the current draw is determined by the circuit resistance, in this case the starter. The CCA means more power available in colder weather. Even if you had 1000 CCA the starter would still use the same amount of current. Check for a loose positive or negative cable somewhere.
Roadworthy
Elite Member
Inspect the ends carefully. Sometimes there will be corrosion inside the connector itself. Immersed in a solution of baking soda and water the reaction will tell you if any acid has crept in there. If replacing wires, bigger never hurts but never go smaller.
oldnslo
Super Member
Look for a ground wire or strap that goes from the engine to frame. Your tractor may or may not have one but If that has come loose or is corroded at connection points will cause high amp draw to the starter.
