I switched bearing plate and flywheel on my 16 hp kohler now have electric start an runs good. I was going to put the electric clutch from the 14 hp on the 16 hp but the shaft on the 16 hp is 1 1/8 and has no threaded hole ( 14 hp has inch shaft and threaded centerhole. Any sugestions Is there a clutch available? Can I drill and tap the crank shaft?
electric clutch?
- Thread starter jgrieve
- Start date
- Views: 1609
Superduper
Platinum Member
- Joined
- Jul 18, 2006
- Messages
- 523
- Location
- Somewhere, over the rainbow.
- Tractor
- John Deere 3120, Kubota BX2350, Deere X740
No threaded hole? How is the clutch retained? Is it pressed in? I'm sure it is possible to drill and tap it but from a practical point of view, it's probably not going to be easy to do it straight.
