Diving into Ham Radio... uh oh!

   / Diving into Ham Radio... uh oh! #81  
Baby steps... radio and power supply hooked up. Antenna is temporarily laying across my rooftop. Need to properly ground the radio and the antenna hopefully today. Started going through the 'knobs' last night. Got my HF, VHF, and UHF charts on the wall behind. Can't read them with the glare and small print. Gonna have to come up with something better for 'wallpaper'. :D

View attachment 674617

Excellent. I can't see the chart very well. Does it show the subband assignments fore each license class?
 
   / Diving into Ham Radio... uh oh! #82  
My 7300 came with a great mic. I added a ICOM desk mic later and used the original hand mic on my ICOM 745 I take camping in a to go box

I have heard lots of guys that use the 7300 mic on older Icom rigs. Apparently the 7300 mic is one of the best they have made in a while.
 
   / Diving into Ham Radio... uh oh! #84  
Baby steps... radio and power supply hooked up. Antenna is temporarily laying across my rooftop. Need to properly ground the radio and the antenna hopefully today. Started going through the 'knobs' last night. Got my HF, VHF, and UHF charts on the wall behind. Can't read them with the glare and small print. Gonna have to come up with something better for 'wallpaper'. :D

View attachment 674617
Listen up on 3960 LSB every evening @ 6pm local for the Columbia Basin Net!
 
   / Diving into Ham Radio... uh oh!
  • Thread Starter
#85  
   / Diving into Ham Radio... uh oh! #89  
Are there a lot of birdies on that radio? I have an old (crappy specs) Kenwood wideband mobile receiver and in scanning mode you come across tons of noise which you don't know if it's local or internally generated. I suspect, it's the radio.
 
   / Diving into Ham Radio... uh oh! #90  
Are there a lot of birdies on that radio? I have an old (crappy specs) Kenwood wideband mobile receiver and in scanning mode you come across tons of noise which you don't know if it's local or internally generated. I suspect, it's the radio.

No, not in a 7300. It is very clean. There are a very few, very weak and they fall outside of the ham bands. I think there was a big one at the bottom of its receive range at 30khz, but who cares. It seems like there was one up around 72 Mhz, but again who cares.
 

Tractor & Equipment Auctions

2007 Freightliner Columbia 120 - Class 8, 6x4, Mercedes MBE4000 Diesel (A51039)
2007 Freightliner...
2003 Ford F-650 Flatbed Truck, VIN # 3FDNW65243MB03484 (A48836)
2003 Ford F-650...
19009 (A48082)
19009 (A48082)
80in HD Tooth Bucket with Side Cutters ONE PER LOT (A51039)
80in HD Tooth...
2017 Bad Boy Outlaw XP 61in Zero Turn Mower (A48082)
2017 Bad Boy...
2019 New Holland C227 Skid Steer (A50657)
2019 New Holland...
 
Top