Disassembling 7360ss shift linkage

   / Disassembling 7360ss shift linkage #1  

VetFan

New member
Joined
Aug 31, 2018
Messages
2
Location
Mims, Florida
Tractor
Cub Cadet 7360ss
Got both cub cadet manuals. Pics indicate a cover on side of center case, labeled "Lever holder" 4 bolts appear to hold it on and I removed them, but short of destroying it, it refuses to come off and the pics are zero help. I disconnected all external linkage, shift is in neutral. Pics look as if it should come up and off, I would gladly welcome any help. The slide lever is leaking about a gallon of hyd. fluid every 2-3 days even while sitting.
 
   / Disassembling 7360ss shift linkage #2  
The shifter on my 7260 SS works good when it's warm outside, but gets hard to go into fwd or rev when it's cold. I haven't found any lub points. Anyone else with the same problem or suggestions to fix. Was also very hard to start the engine when it's cold, so I put the glow plugs on a manual system with a switch and a 180 amp fuse directly from the battery to the glow plugs. Turn it on for 8 seconds, starts every time.
 

Tractor & Equipment Auctions

2005 Mitsubishi Lancer ES Sedan (A51694)
2005 Mitsubishi...
2018 New Holland T8.350 MFWD Tractor (A53342)
2018 New Holland...
2019 Club Car Carryall 1700 4x4 Diesel Utility Cart (A51691)
2019 Club Car...
Ingersoll Rand Air Compressor (A51573)
Ingersoll Rand Air...
2025 New/Unused Wolverine Hydraulic Skid Steer Pallet Forks (A51573)
2025 New/Unused...
2013 Chevrolet Silverado 3500HD Enclosed Service Truck (A52377)
2013 Chevrolet...
 
Top