Delta drill press ACME nut

   / Delta drill press ACME nut
  • Thread Starter
#11  
It’s definitely an acne thread.
 
   / Delta drill press ACME nut
  • Thread Starter
#12  
1738027754314.jpeg
 
   / Delta drill press ACME nut #13  
FWIW: @90cummins if you can knurl it, ACME 3/4-10 round internally threaded is available from the usual folks.
McMaster, Roton, etc. Bronze and steel.

All the best,

Peter
 
   / Delta drill press ACME nut
  • Thread Starter
#14  
I’m aware that I can work around it, just didn’t think it would be a big deal!
Parts for this old iron is pricey😬
Thank you for the advice 👍
 
   / Delta drill press ACME nut #15  
I’m aware that I can work around it, just didn’t think it would be a big deal!
Parts for this old iron is pricey😬
Thank you for the advice 👍
Welcome to the club!
 
   / Delta drill press ACME nut #16  
3/4-10 isnt a common acme thread.

If you can indeed get the direct replacement for $35.....probably well spent.
 
   / Delta drill press ACME nut #17  
If that is your photo in the OP, then it sure doesn't look like Acme. 3/4-10 is the stand UNC coarse thread in that size. I'd at least try a cheap stock nut from the farm store first to verify...
 
   / Delta drill press ACME nut
  • Thread Starter
#18  
I found a 3/4-10 bolt & nut in my catch all pile and put it up to the acme the thread and it is a perfect match at 10 threads per inch and NO the nut does not turn on the acme rod.
 

Tractor & Equipment Auctions

2003 GROVE TMS500E MOBILE TRUCK CRANE (A51406)
2003 GROVE TMS500E...
New Long Forks (A53002)
New Long Forks...
2016 Hino 195h Truck, VIN # JHHSPM2H6GK001602 (A51572)
2016 Hino 195h...
2016 Big Tex 14LX 14ft 7 Ton T/A Dump Trailer (A50322)
2016 Big Tex 14LX...
2018 Gatormade 20+5 Gooseneck Trailer (A52748)
2018 Gatormade...
2015 INTERNATIONAL DF677 (A52472)
2015 INTERNATIONAL...
 
Top