Hello: Yes you could safely redo the wiring to make the lights able to be turned off. Trace the wiring harness to the bulbs, Find the hot wire with a test light with the bulbs removed and the engine at idle. Then you'll need to find in the harness where the left and right headlight bulb hot wire are joined together. right before that junction cut the wire and run a wire back to the dash where you want the switch. then run another wire back from the switch to the original wire opposite where you attached the other switch wire. Whollaaa!!!! you now have switchable headlights. If you have tailights you could do some more tracing and make them switched on the same switch. Only be sure to use wire NO lighter than the factory wire and a switch rated at 30 amps. Hope this helps, Justin. /forums/images/graemlins/wink.gif