Control Question
- Thread starter Trkrd
- Start date
- Views: 3484
C
careyo63
Guest
If it's the one in front in between your legs. It locks your HYD. lift in place so it won't move.
Carey
Carey
C
careyo63
Guest
Say you have something attached to the lift and it can't touch the ground, tractor running or not, screw it in and it will keep it from going down or going up also if its running.
Carey
Carey
HoyeTractor
Gold Member, Approved Advertiser
Edit: oops Carey beat me to it 
It just prevents the lift from going down. I believe it was designed to allow you to raise the three point, screw in the valve, and then not have to worry about accidentally lowering it. Like for example, you have a tiller attached and are doing some loader work. At least that is the way I have always pictured it working.
Aaron
Hoye Tractor Parts
Contact Us
(940)592-0181
It just prevents the lift from going down. I believe it was designed to allow you to raise the three point, screw in the valve, and then not have to worry about accidentally lowering it. Like for example, you have a tiller attached and are doing some loader work. At least that is the way I have always pictured it working.
Aaron
Hoye Tractor Parts
Contact Us
(940)592-0181
dex3361
Elite Member
- Joined
- Aug 22, 2008
- Messages
- 3,494
- Location
- N. of Charleston WV
- Tractor
- Kubota L4400-1 HST,FEL, 3x3 remotes, TNT. BX1500 54 mmm
Its also a speed control for the 3PH lift so if you want to slow the up/down movement. You turn it clockwise facing the knob will slow the up/down movement.
HoyeTractor
Gold Member, Approved Advertiser
California
Super Star Member
- Joined
- Jan 22, 2004
- Messages
- 15,029
- Location
- An hour north of San Francisco
- Tractor
- Yanmar YM240 Yanmar YM186D
Closed, that knob chokes the return line from the 3point. Then the 3point will stay up indefinitely even with the lift lever moved forward.
You can feel that this takes the load off the engine, idling or driving around, when you have a heavy implement held off the ground.
There is a different, smaller knob (or t-handle) to slow the descent rate of the rear implement. On some models it is under the left side of the seat. The manual says the big knob should be full open or full closed, with the small one adjusted to where an implement glides down instead of crashing.
You can feel that this takes the load off the engine, idling or driving around, when you have a heavy implement held off the ground.
There is a different, smaller knob (or t-handle) to slow the descent rate of the rear implement. On some models it is under the left side of the seat. The manual says the big knob should be full open or full closed, with the small one adjusted to where an implement glides down instead of crashing.