ajmaxham
Bronze Member
A set of small bucket forks I built for a friend.
Clamp on bucket forks
- Thread starter ajmaxham
- Start date
- Views: 3296
Thomas
Epic Contributor
- Joined
- Apr 6, 2000
- Messages
- 31,811
- Location
- Lebanon,NH.
- Tractor
- Kubota B2650HSD w/Frontloader & CC LTX1046 & Craftman T2200 lawn mower.
Somemore of that good ole yankee ingenuity. 
Bob77064
Elite Member
Good job.
droptop
Gold Member
They look a lot better than most of the clamp on sets that you can buy!
Xfaxman
Super Star Member
- Joined
- Feb 8, 2013
- Messages
- 13,293
- Location
- Guthrie, OK
- Tractor
- Toolcat 5610 G - Bobcat V417 - TORO+Loader
Gooder-uns :thumbsup:
What where the forks? Can't figure out the groove on the side.
What where the forks? Can't figure out the groove on the side.
k0ua
Epic Contributor
I am betting that is where he welded up 1/2 inch bar stock stacked on top of each other. See the plug welds on top?
Xfaxman
Super Star Member
- Joined
- Feb 8, 2013
- Messages
- 13,293
- Location
- Guthrie, OK
- Tractor
- Toolcat 5610 G - Bobcat V417 - TORO+Loader
Yep, I do now!
OP
ajmaxham
Bronze Member
The metal in the forks started life as dock hardware. It is 5/16'' by 2'' flat bar with holes every 8'' that I stacked on each other. Off set the holes so I could plug weld every 4'' and weld at both ends. So far they have worked very well.
