CHIPPER/SHREDDER FOR PT 422?
- Thread starter BruceL
- Start date
- Views: 750
MossRoad
Super Moderator
- Joined
- Aug 31, 2001
- Messages
- 63,317
- Location
- South Bend, Indiana (near)
- Tractor
- Power Trac PT425 2001 Model Year
Haven't seen any, yet. There has been some discussion as to converting some from engine or PTO shaft to hydraulic motor drive.
cqaigy
Silver Member
My Dad bought one of those 5hp chipper/shredders that had bad engine that somebody had left out in the weather last weather and it filled the engine w/water (yes we get that much rain here). The cost to fix/replace the engine was too high so the owner sold the chipper for $25. My Dad was thinking of having it around for spare parts because we both have similar types. I"ve been eyeing it and thinking about putting a hydrolic motor on it but I have a working one that I bought for $20 so......
MossRoad
Super Moderator
- Joined
- Aug 31, 2001
- Messages
- 63,317
- Location
- South Bend, Indiana (near)
- Tractor
- Power Trac PT425 2001 Model Year
I thought about it too. I went to a local lawn and garden shop and he had several used ones that had good engines. He said he would take the engine off of it and kncok $100 bucks off the price. I figure a good hydraulic motor will run a couple hundred minimum, plus hoses, pulleys and belts for proper gearing, etc... so, I wait until I can find one with a dead engine for little $$. (I'm frugal... OK, I'm cheap /forums/images/graemlins/grin.gif)
Schultz
Gold Member
Ingersoll makes one but it's expensive. Probibly better off adapting someone elses.
Ingersoll chipper
Ingersoll chipper
