CHIPPER/SHREDDER FOR PT 422?

[BruceL]

are there any hydraulic chipper/shredders available that would work as attachments to a pt 422?

thanks,
bruce

 

[MossRoad]

Haven't seen any, yet. There has been some discussion as to converting some from engine or PTO shaft to hydraulic motor drive.

 

[BruceL]

hmmmm......sounds like a complex project.
thanks for the input!

bruce

 

[cqaigy]

My Dad bought one of those 5hp chipper/shredders that had bad engine that somebody had left out in the weather last weather and it filled the engine w/water (yes we get that much rain here). The cost to fix/replace the engine was too high so the owner sold the chipper for $25. My Dad was thinking of having it around for spare parts because we both have similar types. I"ve been eyeing it and thinking about putting a hydrolic motor on it but I have a working one that I bought for $20 so......

 

[MossRoad]

I thought about it too. I went to a local lawn and garden shop and he had several used ones that had good engines. He said he would take the engine off of it and kncok $100 bucks off the price. I figure a good hydraulic motor will run a couple hundred minimum, plus hoses, pulleys and belts for proper gearing, etc... so, I wait until I can find one with a dead engine for little $$. (I'm frugal... OK, I'm cheap /forums/images/graemlins/grin.gif)

 

[Schultz]

Ingersoll makes one but it's expensive. Probibly better off adapting someone elses.

Ingersoll chipper