Case IH 885 PTO shaft R&R

   / Case IH 885 PTO shaft R&R #1  

groundhawg

New member
Joined
Jun 26, 2007
Messages
17
Location
Huntsville, TX
I have a '90 Case IH 885 2wd no cab. I broke my 540 PTO shaft with a stump grinder and found out yesterday this is not an easy fix! The PTO gear is to big to fit out of the hole in the case and there is a snap ring on the back side. This requires removing top cover from rear axle/hydraulic housing to gain access.
If anyone has a shop manual or experience with this procedure and could offer some insight I would be very grateful! I am pulling sheet metal, fuel tank and rops now. Thanks!
 
   / Case IH 885 PTO shaft R&R #3  
Sorry i couldn't help as I have no experience with your problem, but it sounds like you made it fine. I can understand your concern with doing a job with no experience or guidance. I've found that you just have to get started and it usually works out. Congratulations on getting it done.
 

Tractor & Equipment Auctions

Toyota Prius NR (A50324)
Toyota Prius NR...
2012 Chevrolet Cruz Sedan (A50324)
2012 Chevrolet...
1998 SHERMAN +REILLY 6048 SINGLE DRUM LINE PULLER (A50322)
1998 SHERMAN...
2019 POLARIS RANGER XP PROSTAR 900 HD DOHC UTV (A51406)
2019 POLARIS...
Kivel Pallet Forks (A50121)
Kivel Pallet Forks...
Neckover GL24-2-7K Gooseneck Trailer  24ft Deck, Dual 7K Axles, 14K GVWR (A52748)
Neckover GL24-2-7K...
 
Top