Cab heat

   / Cab heat #1  

Tunder123

New member
Joined
Jan 18, 2014
Messages
3
Location
Delaplane va
Tractor
Kubota m7040
Any help please? My. M7040 kubota. Is not pushing out heat in cab, has been flushed and thermostat replaced engine temp is normal blower works but only cold air.:(
 
   / Cab heat #2  
air in the line.
 
   / Cab heat #3  
hmmm, when you rotate the heat level dial, can you feel resistance. There should be a cable that connects from the dial to the valve directing flow of hot water thru the coil. There is also duct that controls air flow thru the exchanger.
 
   / Cab heat #4  
check both hoses going in and out of the cab for heat. There could be a problem in the control but it is not normal.
 
   / Cab heat
  • Thread Starter
#5  
Have checked both hoses going in to cab they seem cool to touch? Shouldn't one be warm?
 
   / Cab heat #6  
Have checked both hoses going in to cab they seem cool to touch? Shouldn't one be warm?

yes, on mine one is very hot to the touch. What i dont know is what tells the lines to open and make hot water flow thru system. There must be a control valve up in your unit. In automobiles, there is a cable the directs amount of hot water flowing thru condenser coil i believe....at least thats my understanding. In this way when you go into A/C mode, the hot water doesnt flow thru unit. This cable connects to the dial that controls amount of heat
 
   / Cab heat #7  
Have you checked for any blown fuses? Heat is controlled by electric servo motor. How high is temp gauge getting after 30 minutes of engine operation????
 
   / Cab heat #8  
Do you smell anything funky? Maybe some mice built a nest in the fan or general area.
 
   / Cab heat
  • Thread Starter
#9  
Engine gauge in the normal range,fuses under steering all good are there. Others? Control knob does not have a lot of resistance ? Will work on it again tomorrow
 
   / Cab heat #10  
Engine gauge in the normal range,fuses under steering all good are there. Others? Control knob does not have a lot of resistance ? Will work on it again tomorrow

the control knob on most a/c heat units should have resistance as it is connected to a cable that leads to the valve allowing hot water to flow thru heater core. Im not familiar with the Kubota system, but i doubt it varies much from the average car heater in that respect.
 

Tractor & Equipment Auctions

GODWIN CD150M DRI PRIME PORTABLE PUMP (A51406)
GODWIN CD150M DRI...
COOPER LIGHTING CAT. NO. MHEP-22/28-175-MT (A53472)
COOPER LIGHTING...
2003 International 7400 T/A Heil 12 CuYd Dump Truck (A51692)
2003 International...
2025 25ft. 800Amp Extra HD Booster Cables (A51692)
2025 25ft. 800Amp...
2004 Fleetwood Wilderness Advantage 365 BSQS 38FT T/A 5th Wheel Travel Trailer (A53424)
2004 Fleetwood...
2012 Freightliner M2 106 Braun Ambulance (A51692)
2012 Freightliner...
 
Top