Mitch I guess I wasn't clear. The KK Blade where I made those metal
bushings? Well those "Extend" the lower implement draw pins by about
2" each, w/o them the QH bottom hooks do not reach the Implement.
So they extend and bring up to size. I am not done w/ them and
I have not elaborated on them on purpose. I should get the
.5" x 1.5" roll pins I want for them today I would think. After
I do there will be a better explaination, but to answer your question
yes I have seen those and I am not thrilled about them, I have
seen them in all flavors/sizes I should say.
I ran into an interesting QH Top QC that has promise
HERE.
Here is a pic of it;
That would stop the top from wanting to jump "almost" out.
I am not done thinking about that yet.
I also found a 7/8" x 3.5" plain pin but below it on the same
page there are some stop collars...
HERE. (I am not sold on
that issue yet either. )