BryanM
Gold Member
Does anyone know if you can buy 2.25 x 2 channel? I have looked all over on websites and do not see that size!
Buying metal.
- Thread starter BryanM
- Start date
- Views: 1707
civesnedfield
Platinum Member
- Joined
- Jun 18, 2007
- Messages
- 600
- Location
- Central Maine
- Tractor
- 2007 Mahindra 4530----1972 Massey Ferguson 1100
Does anyone know if you can buy 2.25 x 2 channel? I have looked all over on websites and do not see that size!
I don't believe you can. Here is a link for a supplier and he carries the smaller stuff and nothing 2 1/4
MetalsDepot? - Hot Rolled A36 Steel Channel
tommu56
Elite Member
Were you are has more to do with it there is 3 steel yards with in 20 miles of me and 2 good scrap yards.
hit the phone book
tom
hit the phone book
tom
where you live may have a little to do with availability, but in the end, it's a matter of what the mills roll. that metals depot link is a good reference as to what's available. the 3" and up are generally referred to by their depth and weight per lineal foot, and the smaller ones are referred to as bar channel. i've used a lot of 5 inch and smaller in the past, and those sizes are pretty much what's available anywhere.
if you need a specific size - 2 1/4x2 - you can always take a 2x2x1/4 angle and weld a 2x1/4 flat to one of the toes, and voila - you have a 2 1/4x2x1/4 channel. another option is to have a fab shop bend plate of the desired thickness to the size you need, but expect to pay $70 +/- an hour plus material. your labor welding will be cheaper.
also, you can probably take civesnedfield's word when it comes to steel shapes. knowing who he is and where he works, he had better know.
if you need a specific size - 2 1/4x2 - you can always take a 2x2x1/4 angle and weld a 2x1/4 flat to one of the toes, and voila - you have a 2 1/4x2x1/4 channel. another option is to have a fab shop bend plate of the desired thickness to the size you need, but expect to pay $70 +/- an hour plus material. your labor welding will be cheaper.
also, you can probably take civesnedfield's word when it comes to steel shapes. knowing who he is and where he works, he had better know.
Scotty370
Platinum Member
- Joined
- Dec 18, 2008
- Messages
- 896
- Location
- Buffalo, New York
- Tractor
- 318 John Deere, 4200 John Deere, 1947 John Deere "M"
http://www.metalsupermarkets.com/msc-storefinder.aspx
Maybe? Found 2x2.32, close as I could come! Application???
Maybe? Found 2x2.32, close as I could come! Application???
It's not made.
If you need lengths 10' or less a well equipped fab shop can form it from sheet or plate.
davygp38
Gold Member
Goes without saying, "It'll cost ya."
